Bad data sends drone into the blue

    10204
    The Pulse Aerospace Vapor 35, similar to the company's 55 model, as seen on Pulse Aerospace's YouTube Channel

    Incorrect data entry caused a remotely piloted aircraft (RPA) to fly out to sea never to return during a test flight in September, Australia’s crash investigator has found.

    The Pulse Aerospace Vapor 55 RPA, more commonly known as the ‘Little Ripper’, was operating over Lighthouse Beach in Ballina, NSW, when it flew out of sight after losing the data-link signal to the controlling pilot.

    In its investigation, the Australian Transport Safety Bureau (ATSB) discovered that during flight planning the RPA was given coordinates for the wrong hemisphere, causing the drone to think its ‘Home’ location was in the middle of the Coral Sea, some 1,200 km north.

    Upon losing the data link seven minutes into the flight, it’s believed the RPA tried to return ‘Home’, attempting to fly to the Coral Sea location, before most likely crashing into the ocean after running out of battery.

    Despite an extensive search, it could not be found.

    ‘Incorrect reference data can have potentially serious consequences in remotely piloted and manned aircraft,’ said the ATSB. ‘It is imperative that remotely piloted aircraft systems incorporate means of minimising the opportunity for errors to occur and also for detecting and correcting errors that do occur.’

    Data input errors are a common human factor occurrence across all sectors of aviation with consequences ranging from aborted take-offs through to collisions with the ground. Errors can occur irrespective of pilot experience, operator, aircraft type, location and take-off performance calculation method.

    In fact, as Flight Safety Australia recently covered, one mistyped digit in 2009 almost led to what could have been the worst crash in the history of Australian aviation, when an Emirates A340 almost failed to take-off due to the flight crew entering an incorrect take-off weight.

    While no one is immune to data input errors, risk can be significantly reduced through effective management and systems. Good communication and independent cross-checks between pilots, effective operating procedures, improved aircraft automation systems and software design, and clear and complete flight documentation will all help prevent or uncover data entry errors.

    Read the full investigation report via the ATSB’s website.

    2 COMMENTS

    1. They mention more automation as a possible solution to the problem. In my experience over reliance and a lack of distrust in automation is where things go pear shaped. I know a 600hr pilot who flew 30min out to sea in good wx ..90degrees to the correct course which would have taken him over islands the whole way because he was blindly following a GPS with incorrect input. Use the tech by all means.. Just don’t trust it entirely.

      Ken
      CPL (H)
      RPAS Controller
      Commercial skipper.

    Leave a Reply to Walter Riley Cancel reply